涂刷乳胶漆工艺流程.doc

涂刷乳胶漆工艺流程 涂刷乳胶漆工艺流程提要：乳胶漆涂刷的施工方法可以采用手刷、滚涂和喷涂。涂刷时应连续迅速操作,一次刷完。涂刷乳胶漆时应均匀，不能有漏刷、流附等现象。 涂刷乳胶漆工艺流程 1．主要施工工艺 清扫基层→填补腻子,局部刮腻子,磨平→第一遍满刮腻子,磨平→第二遍满刮腻子,磨平→涂刷封固底漆→涂刷第一遍涂料→复补腻子,磨平→涂刷第二遍涂料→磨光交活。 2．施工要点 基层处理是保证施工质量的关键环节,其中保证墙体完全干透是最基本条件，一般应放置10天以上。墙面必须平整,最少应满刮两遍腻子,至满足标准要求。 乳胶漆涂刷的施工方法可以采用手刷、滚涂和喷涂。涂刷时应连续迅速操作,一次刷完。 涂刷乳胶漆时应均匀，不能有漏刷、流附等现象。涂刷一遍，打磨一遍。一般应两遍以上。 3．注意事项 （1）腻子应与涂料性能配套，坚实牢固，不得粉化、起皮、裂纹。卫生间等潮湿处使用耐水腻子。 （2）涂液要充分搅匀，粘度太大可适当加不，粘度小可加增稠剂。 （3）施工温度高于10摄氏度。室内不能有大量灰尘。最好避开雨天。 Measures for the routine management of moral education in Middle SchoolsMethod of conventional management of moral education in middle schoolFirst, the guiding ideology:School moral education is an organic whole of the whole education work, always adhere to the school adhere to the moral education, education for this product, and actively promote the quality education, the school building efficient curriculum system of moral education, moral education, improve the sense of attraction and appeal, enhance the moral education work for through and timeliness. Teach everyone, service education and management education, and school moral education work must be with family education and community education closely together, to form a concerted pattern, and strive to create a good atmosphere for education, and to promote the all-round development of students, to establish a scientific moral education full of vigor the For long-term mechanism.Two, the goal of moral education:To guide the students to form the correct world outlook, outlook on life, values, to cultivate students unity and mutual assistance, honest and trustworthy, law-abiding, good quality, hard work, set a good XX students ideological quality, psychological quality and image quality. The formation of excellent moral education curriculum system and management system, the construction of school. The society, family moral education network, to achieve full member education, environment education, education service peo