350-026题库.docVIP

QUESTION NO: 239 The output of the show frame-relay pvc command shows PVC STATUS = INACTIVE. What does this mean? A. The PVC is configured correctly and is operating normally, but no data packets have been detected for more than five minutes. B. The PVC is configured correctly, is operating normally, and is no longer actively seeking the address of the remote router. C. The PVC is configured correctly, is operating normally, and is waiting for interesting traffic to trigger a call to the remote router. D. The PVC is configured correctly on the local switch, but there is a problem on the remote end of the PVC. E. The PVC is not configured on the local switch. Answer: D Explanation: Explanation The PVC STATUS displays the status of the PVC. The DCE device creates and sends the report to the DTE devices. There are 4 statuses: + ACTIVE: the PVC is operational and can transmit data + INACTIVE: the connection from the local router to the switch is working, but the connection to the remote router is not available + DELETED: the PVC is not present and no LMI information is being received from the Frame Relay switch + STATIC: the Local Management Interface (LMI) mechanism on the interface is disabled (by using the “no keepalive” command). This status is rarely seen so it is ignored in some books. QUESTION NO: 241 Refer to the exhibit. 202In the Frame Relay network, which IP addresses would be assigned to the interfaces with point-to-point PVCs? A. DLCI 16: 192.168.10.1 /24 DLCI 17: 192.168.10.1 /24 DLCI 99: 192.168.10.2 /24 DLCI 28: 192.168.10.3 /24 B. DLCI 16: 192.168.10.1 /24 DLCI 17: 192.168.11.1 /24 DLCI 99: 192.168.12.1 /24 DLCI 28: 192.168.13.1 /24 C. DLCI 16: 192.168.10.1 /24 DLCI 17: 192.168.11.1 /24 DLCI 99: 192.168.10.2 /24 DLCI 28: 192.168.11.2 /24 D. DLCI 16: 192.168.10.1 /24 DLCI 17: 192.168.10.2 /24 DLCI 99: 192.168.10.3 /24 DLCI 28: 192.168.10.4 /24 Answer: C Explanation: With point to point PVC, each connection needs to be in a separate subnet. The R2-R1 co