注射成形和模压成形Cu-10Ni合金的烧结行为.pdfVIP

学兔兔 第14卷第1期 粉末冶金材料科学与工程 2009年2月 Vb1．14NO 1 Materials Science and Engineering of Powder Metallurgy Feb．2009 注射成形和模压成形Cu．1ONi合金的烧结行为 冯 颖，李益民，曾昭易，何 浩 (中南大学 粉末冶金国家重点实验室，长沙 410083) 摘 要：分别采用模压成形和注射成形技术制备Cu．10Ni合金，研究该合金不同成形方式下的烧结行为。结果表 明：合金的致密化过程和力学性能均受烧结温度的显著影响，烧结过程均包括合金化、均匀化和致密化3个阶段。 模压成形坯在1 000℃、注射成形坯在1 050℃烧结后，致密化程度均较高、显微组织较好、力学性能较佳。其 中，注射成形制备的Cu-Ni合金表现出致密化过程较长、滞后于模压成形合金的烧结行为，完成烧结所需的温度 较高。 关键词：模压成形；注射成形；Cu—Ni合金；烧结行为 中图分类号：TF124 文献标识码：A 文章编号：1673．0224(2009)1-42—06 Sintering behavior of Cu—l ONi alloys shaped respectively by Mold-pressing and metal inj ection molding techniques FENG Ying，LI Yi—min，ZENG Zhao—yi，HE Hao (State Key Laboratory of Powder Metallurgy，Central South University，Changsha 410083，China) Abstract：Sintering behavior of Cu··10Ni alloys shaped by mold·-pressing and metal injection molding techniques has been examined．The results show that the densification behavior and mechanical performances are influenced by sintering temperature evidently．During sintering，the alloy exhibits the processes of alloying，homogenization and densification． The highest density,optimal microstructure and required mechanical performances are realized by sintering at 1 000 ℃ and 1 050℃ for the alloys shaped by mold·pressing and metal injection molding processes．respectively．And the densification process of the Cu·Ni alloy shaped with metal injection molding is retarded and slower，and higher suitable sintering temperature is necessary，comparing with that