脚手架工程材料要求.docVIP

脚手架工程材料要求 脚手架工程材料要求提要：扣件：采用可锻造铸铁制作的扣件，其材质应符合现行国家标准《钢管脚手架扣件》的规定。新扣件必须有产品合格证 更多精品源自制度 脚手架工程材料要求 1、钢管：钢管采用外径48～51mm，壁厚3～的管材。钢管应平直光滑，无裂缝、结疤、分层、错位、硬弯、毛刺、压痕和深的划道。钢管应有产品质量合格证，钢管必须涂有防锈漆并严禁打孔。 脚手架钢管的尺寸应按表1采用，每根钢管的最大重量不应大于25kg。 表1脚手架钢管尺寸 截面尺寸最大长度 外径φ壁厚t横向水平杆其他杆 48　 322017500 2、扣件：采用可锻造铸铁制作的扣件，其材质应符合现行国家标准《钢管脚手架扣件》的规定。新扣件必须有产品合格证。 旧扣件使用前应进行质量检查，有裂缝、变形的严禁使用，出现滑丝的螺栓必须更换。 3、脚手板：脚手板可采用钢、木材料两种，每块重量不宜大于30kg。 冲压新钢脚手板，必须有产品质量合格证。板长度为～，厚2～3mm，肋高5cm，宽23～25cm，其表面锈蚀班点直径不大于5mm，并沿横截面方向不得多于3处。脚手板一端应压连接卡口，以便铺设时扣住另一块的端部，板面应冲有防滑圆孔。 木脚手板应采用杉木或松木制作，其长度为2～6m，厚度不小于5cm，宽23～25cm，不得使用有腐朽、裂缝、斜纹及大横透节的板材。两端应设直径为4mm的镀锌钢丝箍两道。 4、安全网：宽度不得小于3m，长度不得大于6m，网眼不得大于10cm，必须使用维纶、锦纶、尼龙等材料，严禁使用损坏或腐朽的安全网和丙纶网。密目安全网只准做立网使用。 Measures for the routine management of moral education in Middle SchoolsMethod of conventional management of moral education in middle schoolFirst, the guiding ideology:School moral education is an organic whole of the whole education work, always adhere to the school adhere to the moral education, education for this product, and actively promote the quality education, the school building efficient curriculum system of moral education, moral education, improve the sense of attraction and appeal, enhance the moral education work for through and timeliness. Teach everyone, service education and management education, and school moral education work must be with family education and community education closely together, to form a concerted pattern, and strive to create a good atmosphere for education, and to promote the all-round development of students, to establish a scientific moral education full of vigor the For long-term mechanism.Two, the goal of moral education:To guide the students to form the correct world outlook, outlook on life, values, to cultivate students unity and mutual assistance, honest and trustworthy, law-abiding, good quality, hard work, set a good XX students ideological quality, psychological quality and image quality. The