轧尖机工的安全操作规程.docVIP

轧尖机工的安全操作规程 轧尖机工的安全操作规程提要：要检查毛料的实际尺寸，几何形状和硬度是否符合规定。禁止加工未经退火的棒料，防止挤裂轧辊或崩出碎块伤人 于房地产E网 轧尖机工的安全操作规程 1．工作前检查材料支架是否稳固，机床开关是否有效，齿轮防护罩是否牢固。 2．开机前，要整理工作地和机床上的工具、杂物。 3．调整轧辊间隙时，间隙压力不能太大，防止把料轧裂。轧尖时，要逐渐加压，不要一次轧成。 4．要检查毛料的实际尺寸，几何形状和硬度是否符合规定。禁止加工未经退火的棒料，防止挤裂轧辊或崩出碎块伤人。 5．操作工向下扔料时，要注意周围人的安全。剪开捆料铁丝时，要防止棒料滚动或铁丝弹出伤人，捆料铁丝要及时清理掉。 6．送料轧尖时，必须握紧料棒，防止棒料滑动或翘起，加工直径在18毫米以上的料，要两人协同工作，注意协调配合好。 7．轧过尖的料不能用手触摸尖端，防止烫伤。 8．料架位置要适当，不得堵塞通道。 9．排出的废料、边角余料必须放在指定位置。 10．无关人员不准靠近正在轧尖的材料和设备。 11．操作者注意力要集中，坚守岗位，不要左顾右盼。 于房地产E网 Measures for the routine management of moral education in Middle SchoolsMethod of conventional management of moral education in middle schoolFirst, the guiding ideology:School moral education is an organic whole of the whole education work, always adhere to the school adhere to the moral education, education for this product, and actively promote the quality education, the school building efficient curriculum system of moral education, moral education, improve the sense of attraction and appeal, enhance the moral education work for through and timeliness. Teach everyone, service education and management education, and school moral education work must be with family education and community education closely together, to form a concerted pattern, and strive to create a good atmosphere for education, and to promote the all-round development of students, to establish a scientific moral education full of vigor the For long-term mechanism.Two, the goal of moral education:To guide the students to form the correct world outlook, outlook on life, values, to cultivate students unity and mutual assistance, honest and trustworthy, law-abiding, good quality, hard work, set a good XX students ideological quality, psychological quality and image quality. The formation of excellent moral education curriculum system and management system, the construction of school. The society, family moral education network, to achieve full member education, environment