钢筋剥肋滚轧直螺纹连接操作要点.docVIP

钢筋剥肋滚轧直螺纹连接操作要点 钢筋剥肋滚轧直螺纹连接操作要点提要：经验收合格的钢筋按规格、部位堆放，并挂上标识牌。雨期或长期堆放的情况下，对丝头进行覆盖防锈；丝头在运输过程中应妥善保护 来自物业管理资料下载 钢筋剥肋滚轧直螺纹连接操作要点 ★钢筋下料要求端部平直，不得用电焊、气割焊等方法切断。钢筋端面平直并与钢筋轴线垂直，不得有马蹄形或扭曲； ★套丝工人均应相对固定，经培训后持证上岗。套丝工人应逐个目测检查套 丝质量，并抽检10％丝头，用螺纹规进行检查。 ★套丝时所用切削润滑液应经常更换，必须加润滑液进行套丝。 ★加工的钢筋丝头的直径和长度应用螺纹量规检查，保持在规定的波动范围内。 ★现场连接钢筋时，应使套筒两端钢筋相互顶紧，并保持套筒的居中位置，两端外露扣不超过一个完整丝扣。 ★经验收合格的钢筋按规格、部位堆放，并挂上标识牌。雨期或长期堆放的情况下，对丝头进行覆盖防锈；丝头在运输过程中应妥善保护，避免雨淋、沾污、遭受机械损伤。钢筋丝头应用塑料帽保护。 ★在正式施工前，必须进行钢筋滚轧直螺纹连接工艺性能试验。 ★钢筋连接完后必须有专人进行检查，并涂刷油漆作标识。 ★钢筋的规格、接头的位置必须设计规范符合要求。 ★连接钢筋时必须用管钳扳手拧紧，使两钢筋丝头在套筒中央位置相互顶紧，或用锁紧螺母锁紧并加以标记 ★钢筋接头拧紧后应用力矩扳手按不小于下表中的拧紧力矩值检查，并加以标记。 来自物业管理资料下载 Measures for the routine management of moral education in Middle SchoolsMethod of conventional management of moral education in middle schoolFirst, the guiding ideology:School moral education is an organic whole of the whole education work, always adhere to the school adhere to the moral education, education for this product, and actively promote the quality education, the school building efficient curriculum system of moral education, moral education, improve the sense of attraction and appeal, enhance the moral education work for through and timeliness. Teach everyone, service education and management education, and school moral education work must be with family education and community education closely together, to form a concerted pattern, and strive to create a good atmosphere for education, and to promote the all-round development of students, to establish a scientific moral education full of vigor the For long-term mechanism.Two, the goal of moral education:To guide the students to form the correct world outlook, outlook on life, values, to cultivate students unity and mutual assistance, honest and trustworthy, law-abiding, good quality, hard work, set a good XX students ideological quality, psychological quality and image quality. The formation of excellent moral education curriculum system and manageme