门窗工程的施工方法（十二）.docVIP

门窗工程的施工方法（十二） 门窗工程的施工方法（十二）提要：门窗安装：1)首先抄平放线。先通长拉水平线，用墨线弹在侧壁上，从顶层洞口找中，吊垂线，弹窗口中线 更多精品：总结 门窗工程的施工方法（十二） 1、门窗工程加工、定货、安装及验收 本工程外窗采用铝合金窗。安装工作量较大，而且与外墙施工密切配合。这部分工作质量的好坏，不仅关系到门窗的使用，而且关系到工程外面的美观。因此要着重作好以下几点： 铝合金门窗在结构施工期间即开始进行翻样、放样工作，并提前加工订货，确保安装前按时到货进场。 铝合金门窗到货进场后进行严格验收。 门窗表面应色泽均匀，无裂纹、麻点，气孔和明显擦伤。 门窗框与扇应装配成套，并装好全部小五金。 质量、尺寸、规格等与设计要求一致，门窗制作尺寸偏差在规定允许偏差之内。成品编号（使用规定标准代号与标记）正确。 门窗安装： 首先抄平放线。先通长拉水平线，用墨线弹在侧壁上，从顶层洞口找中，吊垂线，弹窗口中线。 安装框子。把门窗框放进洞口的安装线上，用楔子固定，校正侧面垂直度、对角线及水平度合格后，用木楔塞在边框、中竖框、中横框等受力的部位。框子固定后，应及时开启窗扇，检查开关灵活度，待安装完玻璃后，再按原有标记的位置将其安装在框上，用两只木螺丝将铁脚固定在预埋木砖上。 填缝抹口。门窗洞口粉刷前，在门窗周围缝隙内塞入轻质材料，使之柔性连接。门窗框与墙面之间的空隙内注满密封膏。 安装五金玻璃。必须先钻孔，然后用自攻螺丝拧入（严禁直接锤击钉入）。待内外墙粉刷完成后，将玻璃用压条压在扇上。 2、门窗工程注意事项 施工时，不得在门窗上铺搭脚手板，搁支脚手杆或悬挂物体，以免变形。 门窗扇安装前作内外粉刷，在门窗框粘纸条保护。粉刷完成后方可撕下门保护膜。 Measures for the routine management of moral education in Middle SchoolsMethod of conventional management of moral education in middle schoolFirst, the guiding ideology:School moral education is an organic whole of the whole education work, always adhere to the school adhere to the moral education, education for this product, and actively promote the quality education, the school building efficient curriculum system of moral education, moral education, improve the sense of attraction and appeal, enhance the moral education work for through and timeliness. Teach everyone, service education and management education, and school moral education work must be with family education and community education closely together, to form a concerted pattern, and strive to create a good atmosphere for education, and to promote the all-round development of students, to establish a scientific moral education full of vigor the For long-term mechanism.Two, the goal of moral education:To guide the students to form the correct world outlook, outlook on life, values, to cultivate students unity and mutual assistance, honest and trustworthy, law-abiding, good quality, hard work, set a good XX stude