隐框玻璃幕墙质量问题及预防措施.docVIP

隐框玻璃幕墙质量问题及预防措施 隐框玻璃幕墙质量问题及预防措施提要：幕墙向内漏水。这对内装修完毕的工程危害甚大，漏水一般在开启部位和周边及屋沿的封口不良处 隐框玻璃幕墙质量问题及预防措施 隐框玻璃幕墙表面起伏不平，水平线和垂直线扭曲不直，隐框玻璃幕墙最重要的镜面效果被破坏，楼房车辆和行人反映在幕墙镜面严重错、扭拧变形，如同”哈哈镜”，其主要原因为： 1)结构玻璃装配组件在工厂加工制作过程中尺寸误差过大，造成安装上墙时无法在可调范围内校正。 2)承力框架主梃和横梁安装垂直度、水平度未达到设计要求。 3)安装结构玻璃装配组件时，未严格按要求在允许范围内调整。 耐候结构密封变色变脆。可能是采用了错误的密封胶，这些非耐候密封胶在紫外线的照射下发生易老化和变质。 密封胶与被密封物之间产生裂缝，引起水漏气漏。这是由于在注入耐候胶前，未彻底清除被密封物表面的污物，过薄的胶层也会造成裂纹。 隐框玻璃幕墙内墙部位拼接缝间隙过大、错位和搭接不平。主要原因是厂内加工件精度不够或现场安装误差较大、而无法调整。所以必须在现场位置确定后再下料加工、或留下一定余量到现场再安装，以安装后和最佳效果。 幕墙向内漏水。这对内装修完毕的工程危害甚大，漏水一般在开启部位和周边及屋沿的封口不良处。 开启部分漏水一般为开启部位密封不良，五金配件损坏或胶条弹性很差起不到密封作用而造成。劣质五金配件常常给隐框幕墙带来很大危害。高层建筑的开启窗扇常因铰链、执手和锁断裂等引起开启扇从高空坠落或漏水。隐框幕墙制作厂家要选购质量可靠的五金配件。 因周边及屋檐封口不严产生的漏水现象比较复杂。例如对结构相接部位，应采用密封胶或其它措施的接口部位要设计一定余量的搭接接口，接口用密封胶密封，还要注意与土建施工的配合。 Measures for the routine management of moral education in Middle SchoolsMethod of conventional management of moral education in middle schoolFirst, the guiding ideology:School moral education is an organic whole of the whole education work, always adhere to the school adhere to the moral education, education for this product, and actively promote the quality education, the school building efficient curriculum system of moral education, moral education, improve the sense of attraction and appeal, enhance the moral education work for through and timeliness. Teach everyone, service education and management education, and school moral education work must be with family education and community education closely together, to form a concerted pattern, and strive to create a good atmosphere for education, and to promote the all-round development of students, to establish a scientific moral education full of vigor the For long-term mechanism.Two, the goal of moral education:To guide the students to form the correct world outlook, outlook on life, values, to cultivate students unity and mutual assistance, honest and trustworthy, law-abiding, good quality, hard work, set a good XX students ideological q