磨料粘结产品的标志.pptVIP

摘要幻灯片 磨料粘结产品的标志 磨料粘结产品的标志 丁玉才 2005年5月 标准 EN 12413：1999 safety requirements for bonded abrasive products 磨料粘结产品的安全要求 Annex A marking 附录A 标志 定义 bonded abrasive products are production tools that perform their task by cutting a chip or piece from the material being ground. 通过被磨削的材料上切下碎屑或小片来执行工作的生产工具 They consist of abrasives and bond 由磨料和粘合剂组成 材料缩写 Abbreviations for materials 材料缩写 For the purposes of this standard the following definitions and symbols apply. Table 1 - Abrasives 磨料 A Aluminium oxide 氧化铝 B Silicon carbide 碳化硅 Z Zirconia alumina 锆铝 Table 2 -Grit 粒子 Table 3 -Hardness Grade 硬度等级 Hardness grade is designated by a letter of the alphabet “A” being the softest and “Z” the hardest. A-Z由软到硬 Table 3 -Hardness Grade 硬度等级 A B C D extremely soft 超软 E F G _- very soft 极软 H I J K Soft 软 L M N O Medium 中 P Q R S Hard 硬 T U V W very hard 极硬 X Y Z _- extremely hard 超硬 Table 4 – Structure 结构 Wheel structure may be designated by numbers, usually 0 to 14, with higher numbers indicating more open structure. 砂轮结构由数字定义，通常0-14，数字越大表示结构越开放 Table 5 - Type of bond 粘结类型 V Vitrified bond 玻璃化粘结 R Rubber bond 橡胶粘结 RF Reinforced rubber bond 增强橡胶 粘结 B Resinoid and other thermosetting organic bonds 热固性树脂及 其它热固性组织粘结 Table 5 - Type of bond 粘结类型 BF Resinoid bond fibre-reinforced 纤 维增强热固性树脂粘结 E Shellac bond 虫肠结合剂粘结 MG Magnesite bond 菱镁粘结 PL Plastic bond 塑料粘结 Table A.1 Marking of abrasive products 磨料产品标志 Annex A marking A.1 Purpose 目的 A.2 Content of marking 标志内容A.2.1 Marking requirements 标志要求 A.2.1 Marking requirements 标志要求 A.2.1 Marking requirements 标志要求 A.2.1 Marking requirements 标志要求 A.2.1 Marking requirements 标志要求 Table A.2 - Colour codes and design of colour codes 颜色代码和颜色代码设计 A.2.1 Marking requirements 标志要求 Table A.3 -Restrictions of use (RE)使用限制 A.2.1 Marking requirements 标志要求 To column 9 To ensure traceability and identification, the abrasive products shall be marked with the order number, production number or series numb