2014年9月份测验结构设计道理第二次功课(国外英文资料).docVIP

2014年9月份考试结构设计原理第二次作业(国外英文资料) In September 2014, the design principle of the design of the test was second One, a single choice question (70 points in the big question, 20 questions, 3.5 points per question) The purpose of rebar processing is () A. increase the yield strength B. increase the plasticity of the steel Increase the bonding strength of steel and concrete Straighten and remove rust There is a false statement about the loss of prestress. A. sigma s1 is the stress loss caused by friction between the prestressed tendon and the wall of the pipe, only in the latter component In order to reduce the temperature difference between the steel bar and the table, the maintenance method of the secondary temperature can be adopted C. The calculation method of the stress loss sigma s4, which is caused by the elastic compression of the concrete, is the same as in the posttensioned component The effect of increasing the concrete grade on the load capacity (the bending member) is (). Increase the level of reinforcement; Increase the effect of concrete grades; It is equivalent to raise the grade of concrete and raise the bar No improvement Partial prestressed concrete means under normal load () A. allow for tensile stress or limited cracking B. Prestressed steel is less and less stressed C. Only allows for tensile stress One of the measures to improve the extension of the curvature of the beam section is: () (tip: consider the relationship between pressure height, extreme pressure strain and ductility.) A. increase the AS Increase the strength of the bar Increase the strength of the concrete Neither of the above answers is correct The pure non-bonded prestressed concrete beams are compared to the bonded prestressed concrete beams: () A. fracture morphology is the same as development Load - the deflection curve varies across the middle C. In the maximum moment cross section, the prestressed bar changes in the same way as the load changes The following situation (core concre