AutoCAD敕令(国外英文资料).docVIP

AutoCAD命令(国外英文资料) Set the display color for the drawing work area: tool-options - display - color - Set the size of the cross cursor line: tool-options - display - cross cursor size - View the command record: F2 Absolute coordinates: X, Y, Z Relative coordinates: you have coordinates X0, Y0, and then you enter at @x1, Y1, and the absolute value is X0 + X1, Y0 + Y1 Polar coordinates: @ distance Angle Spherical coordinates: Cylindrical coordinates: General coordinates: Enter/Spaces: give a short answer, is thought to repeat a command or refer to the last operation specified point : straight line - starting point (absolute coordinates relative coordinates/polar/refer to the last operation specified points) - the finish (absolute coordinates/relative coordinates/polar/refer to the last operation specified points)/give up (U) Move: move - select the object - designated basis points (absolute coordinates relative coordinates/polar/refer to the last operation specified points) - specify displacement (absolute coordinates/relative coordinates/polar/refer to the last operation specified point) Enlarge graphics: zoom - input ratio factor (nX or nXP)/full/center (C)/(A) the dynamic range (D)/(E)/on A proportion (P)/(S)/window object (W)/(O) - Open/close the orthogonal pattern: ortho/ ortho - on/off Ctrl + L Copy, copy - select the object - L (an object) on the last, choose the/displacement/selection object - specify bp try (D)/(O) - under the specified point/quit/give up (U) - (E) Open/close capture function: F9 Open/close object capture: F3 Open/close grid: F7 Open/close pole tracking: F10 Many line segments: pline - specifies the starting point - specifies the next point/arc/closed (C) (A)/half width/length (L)/(H) to give up (U)/width (W) - specifies the next point/arc/closed (C)/(A) and A half wide (H)/length (L)/give up/width (W) - (U) Mirror copy: mirror - select the object - specify lines to mirror the first point - specifies the image of the second - yes/no - delete