catia受压圆环的受力剖析(国外英文资料).docVIP

catia受压圆环的受力分析(国外英文资料) The force analysis of catia compression ring Publication time: 2012-09-19 09:33? Source: mfcad? Author: daomi? Click: 536 times Download the source file here? One, problem description: There is an internal pressure ring with a diameter of 100mm (0.1 m), outside diameter 200mm (0.2 m), and 20mm in thickness. Internal pressure 60MPa, or 6.0e7 Pa. The concrete diagram is shown below The ring is made of steel. ? This problem can be solved with analytic solution through a small amount of simplification. The formula for its theoretical solution is shown in figure 2. (for the source of these formulas, interested students can find them in the material mechanics book. 4.? The simplification of the problem, because of the symmetry of the problem, is to take the 1/4 of the ring, establish the geometric model, and impose constraints on the finite element. (in fact, for this question can be further simplified into axisymmetric problem, but to do that are difficult to see the students intuitive demonstration, so take a quarter circle). Limit the weekly movement (because the inner circle will not have a weekly Angle increase) on the two interfaces of the 1/4 ring. Restrict the axial movement of the upper surface of the ring or the lower surface of the ring (limiting the possibility of rigid body displacement, but not too much restriction). The constraints and payloads are shown in figure 3 6.? The comparison of theoretical and finite element solutions is shown in figure 4. Note: when using different mesh density, i.e., different units, the finite element solution will be slightly different, but when using CATIA to get solution and the gap between the theoretical solution should not be greater than 5%. ? Second, the solution idea Start CATIA, create a 3D model of a ring, set up the unit, and add the material. Step 2: enter the engineering analysis module, add the fixed constraint, add all the load, solve, see the result A parabolic unit with a length of 10mm