compass2003简略单纯教程(国外英文资料).docVIP

compass2003简易教程(国外英文资料) Doglegs give two curves to the dogs legs. 2, TVDs - the beginning of the looping section and the final vertical depth. Length of Length - enter the Length of the stable segment Push the design from the target This is an option in a suitable curvilinear type design tool. When the azimuth remains constant, it can be used to push the design hole of the well by the target. Enter the target coordinates or select a target. 2, the hole and orientation of the well when the input reaches the target. 3, through the interval length, vertical deep or one of the three parameters, hole deviation in constant build-up rate at the same time, by the borehole track targets backward design. This function is specified in the final well and azimuth and is used to determine the location of the intermediate target. The type of a steady oblique (line) Used to add a steady slope to the specified oblique or vertical. If the slope is less than the current oblique depth, COMPASS will think you want to add this diagonal depth. For example, if your design is currently at a depth of 5,410 feet, you want to add 90 feet of stability, and COMPASS will increase the design to a given depth of 5,500 feet. You can also specify the vertical depth of the stability by selecting a target or entering a specific number. In continuous target Add to list (Add the target to the list) : The dialog box contains a list of targets that have been assigned to the current well, which is used to select the target points to be added to the list of consecutive targets to cross. Click the button to add the selected target to the list of consecutive targets. Remove from list (Remove the target from the list) Click the button to remove the selected target from the list. Dogleg to apply Specify the dogs legs for the selected curve type. Method (way) The Curve Only (single) Each target has a curve. COMPASS will calculate the initial surface Angle of the tool, using only one segment of the arc curve to h