《工程结构》模拟题及标答(国外英文资料).docVIP

《工程结构》模拟题及标答(国外英文资料) (B) Class name: class of engineering structure: class 200 qid a The second three four five six seven eight nine ten Total score The topic points 10 14 12 12 18 34 100 Note: students are not allowed to answer questions on exam paper. One, the choice question (2 points, 10 points) In order to improve the overall stability of the beam, it is the most economical and effective method. (A) increase the cross section (B) increase the lateral support point and decrease (C) the transverse longitudinal stiffening rib (D) changes the load The principle of determining the economic height of liang is. (A) the shortest (B) manufacturing time is the most convenient (C) for construction (D) to avoid the trouble of cross-section The thickness ratio of the pressure wing of the i-girder is in the form of:. (A) the width of the flaps (B) is the width of the flaps (C) the effective width of one third (D) of the flaps of the flaps Calculate the bending strength of the zigzag beam, use the formula, take, the blade of the beam has the thickness ratio not less than that. (A) (B) (C) (D) In the case of welding beams, the positioning of the abdominal plate of the welded girder was resolved in a more robust way. (A) the shear instability may occur and the lateral stiffening rib should be configured (B) the deflection and longitudinal stiffening are likely to occur (C) it may be bending and unstable, and should be equipped with lateral stiffening rib (D) the shear stability and bending instability should occur, and the transverse and longitudinal stiffening ribs should be configured 2, the judgment (2 points, 14 points) The tensile strength of mortar and block in the mortar seam is determined by the strength of the resistance, shear and bending strength of the masonry. () In consideration of the higher thickness ratio of non-load-bearing walls, mu 1 increases with the thickness of the wall. () The high thickness ratio is required to meet the stability of the wall. () The s