《混凝土结构与砌体结构(下)》第09章在线测试 残剩时间：(国外英文资料).docVIP

《混凝土结构与砌体结构(下)》第09章在线测试 剩余时间：(国外英文资料) Concrete structure and masonry structure (bottom) chapter 09 online testing Remaining time: 33:06 The top of the form ? 1, this volume is 20 points out of 20. ??????????????? After you finish the question, please make sure to click the hand in hand button, or you will not be able to record the results of the paper. ??????????????? Dont refresh the page before you hand it in, otherwise your answer will be empty. 1, 1, 1, 1, 5, 5 ? 1, with resistance to overturning moment design value according to the formula of Mr = 0.8 Gr (L2 - Xo) calculation, the Gr is with resistive overturning loads, it is to choose the upper end of a beam spread Angle 45 and floor permanent load within the scope of the masonry structure The sum of the design values The sum of the design values is 50% The sum of the values of C and the standard D, the standard value is 1.2 times ? The span of brick arch is not better than the span of the beam A, 3 m B, 2 m C, 1.8 m D, 1.2 m ? The wall beam calculates the height range only to allow to set up a hole, the wall girder of the multi-storey building, each layer hole appropriate to set in A, different positions, and up and down B, same position, and up and down C, corner, and up and down D, according to the building requirement, and up and down ? The height of the hb should be satisfied when the beams of a single support beam and the masonry of the upper part of the wall are used to support the wall and the load of the wall A, Lo / 8 or more B, Lo / 10 or more C, Lo / 12 or more D, Lo / 15 or more ? During the construction phase of the construction period, the torang beam is checked A, reinforced concrete eccentricity of pull member B, reinforced concrete eccentric compression member C, reinforced concrete beam calculation D, reinforced concrete torsional component calculation Problem 2, multiple choice questions (2 points for each question, 10 points for 5 questions) ? The design content of the wall beam is includ