中南-工程力学纸质功课及谜底(国外英文资料).docVIP

中南-工程力学纸质作业及答案(国外英文资料) Engineering mechanics Learning center: Specialized business: Study number: Surname: A, fills up the topic A rigid body has three forces on the same plane, both of which are F, as shown. The result of the force synthesis is. 2. The cube side length for a, in the apex Angle a and B respectively force Q and P, Mx (P) =, MY (P) =, MY (Q) =, Mz (Q) =. 3. The necessary and sufficient conditions of planar arbitrary force system balance is. 4. Low carbon steel drawing can be divided into four stages. 5. D = 10 mm diameter of specimen, the distance l = 50 mm, tensile fracture after two punctuation between l1 = 63.2 mm, the length of the neck in d1 = 5.9 mm in diameter, the material elongation the delta =, cross section shrinkage bits =, judgment is material (plastic material/brittle material). 6. The ladder pole stress as shown, AB and BC section of the cross sectional area of 2 A and A, respectively, the elastic modulus E, the maximum normal stress of rod, displacement for section C. 7. As shown in figure screw pull force F, the allowable shear stress of known material (tau), allowable compressive stress [sigma bs] and allowable tensile stress [united], screw diameter d, nail head height is h, nut diameter d, the shear strength condition of the screw, compression strength condition, the tensile strength conditions. 8. As shown in figure thickness t of the two pieces of steel plate, respectively, with two d diameter rivet is linked together, subjected to a force F, then each rivet,. 9. The axial size and stress as shown, AB and BC section material is same, d1, d2 = 2 BC segments of the maximum shear stress and AB is equal to the ratio of the maximum shear stress. Not useful in the concentrated force of beam, shear diagram, its change value equal; In the concentrated couple function, beam bending moment diagram is, the change values equal to zero. 11. Here is a simply supported beam, CB on shear the graph is always under the oblique line, CB section cu