元件结构基础规矩(国外英文资料).docVIP

元件布局基本规则(国外英文资料) The basic rules of the component layout 1. According to the circuit module layout, realize the same function of the related circuit is called a module, circuit module of the element should be concentrated to the nearest principle, at the same time, the digital circuit and analog circuit. According to the principle of first big, small, difficult before easy etc., the important unit circuit, the core components should be the priority layout. In the layout, the principle diagram should be referenced in the layout, and the main components are arranged according to the main signal of the single board. The layout should try to meet the following requirements: the overall connection is as short as possible, and the key line is the shortest. High voltage, large current signal is completely separate from small current, low voltage weak signal; The analog signal is separated from the digital signal; High-frequency signals are separated from low-frequency signals; The spacing of high-frequency components is sufficient. Use symmetrical standard layout as much as possible in the same structure circuit. 6. The device layout grid Settings, general layout, IC device grid should be 50-100 mil, small surface mount devices, such as SMT component placement, the grid Settings should be not less than 25 mil. 7. The same type instrumentation components in X or Y direction should be in one direction to prevent the same type of polar discrete component also should strive to be consistent in X or Y direction, facilitate production and inspection. The IC decoupling capacitor should be as close as possible to the power pipe of IC and make it the shortest circuit between the power source and the earth. When the element is laid out, it should be appropriate to consider using the same power source to be put together for future power division. The layout of resistance container elements for impedance matching is arranged according to its property. The series matching resistance i