patrannastran题目集锦(国外英文资料).docVIP

patrannastran问题集锦(国外英文资料) In the Tools - the List - Create the results you want points can be imported into a group, and then can call out from the results file editor in the origin, or display directly. 14, free mode The so-called free mode is the unconstrained mode, and the first six orders are rigid Can you set up the computation and not output f06 files? You can set the Maximum number of Lines in the Solution Parameters, which is the Maximum number of Lines in f06 A method of extracting mass and stiffness matrix using DMAP For a linear analysis or nonlinear analysis of the static force of a structure, the total stiffness matrix is required for each solution. If you want to analyze the total stiffness matrix of the structure and the total mass matrix in the result after another analysis, you can add the following code in nastran: PARAM, EXTOUT, DMIGPCH Direct input in patran will result in a.pch file containing the required total stiffness matrix and the total mass matrix. If you want to output the total stiffness matrix or the total mass matrix in the solution, you need to use the DMAP language. Msc. Nastran can form the following output file The Job_name.dball contains the permanent data that the database is running The general dictionary running the job_name.master database Job_name. F04 contains the database file information and module execution summary Job_name.f06 contains the analysis result of msc. Nastran for the text file. Job_name.log contains system information and system error information Job_name.op2 msc. Nastran analysis of the binary file The analysis of job_name.xdb msc.nastran is a binary file 18, spring Spring position is defined by two nodes, spring is the only designated degree of freedom under the direction stiffness of the unit, so in a defined spring, also must specify the direction of degrees of freedom of the spring (UX, UY, etc.) for example, spring tension and compression is only in the x direction, define DOF as UX. The degree of fre