先张法预应力砼空心板预制施工工法(国外英文资料).docVIP

先张法预应力砼空心板预制施工工法(国外英文资料) In the process of processing and making, the steel frame and structural reinforcement are formed according to the drawing design, and then bind, the position of each rib is accurate and the binding is strong. Rebar binding and forming drawings The 5.2.6 template installation The lateral module shall be numbered first, and the position of the side module shall be easy to assemble and stand, and the side die and sole shall be fastened to the top of the bolt. The sealing of the sea cotton, the top side adopts the bolt pull rod, the two sides take the method of the flower blue bolt to pull, make it not produce the running mode and the leakage phenomenon in the construction. After a good model, strict inspection of the geometrical size, the isolation agent on the template should not be contaminated with the reinforcement 5.2.7. Gas capsule installation: After the side mode is installed, wear the capsule, use the full check before use, think no leakage phenomenon can be used. 52.8 prestressed reinforcement (105% F) Pneumatic capsule installation, steel binding, and side form after the installation of a second tensioning prestressed reinforcement (i.e., end pull) tension to tension in order to meet the requirements for the design requirements of load 105% of the profit. And last two minutes. 5.2.9 the inflatable capsule inflated Capsule placed later, after the second tensioning of aeration, air pressure control in 5 kg/cm2, inflatable after strict inspection control capsule floating reinforced whether complete, and correct rear can continue casting concrete side plate 5.2.10 concrete is poured Due to the floor, concrete casting requirements fully to ensure that the concrete close-grained, plate vibrator operation should be adopted for vibration, vibration, vibrator are forbidden to encounter steel strand, vibrating again and again until no longer sinking compacted concrete, but not too, surface is smooth, pan pulp. The side slab concrete is cast b