冲压剪切下料件 公差(JB4381-87)(国外英文资料).docVIP

冲压剪切下料件 公差(JB4381-87)(国外英文资料) ? Standards of the state machinery industry committee of the Peoples Republic of China ? JB4381-87. Press shearing material tolerances 1 the introduction ????? This standard stipulates the use of the type of dragon gate type, open shearing machine, cutting thickness is 12mm of metal plate, which is suitable for the size and the elements of the unmarked tolerance on the drawing. ????? This standard is suitable for cutting parts of automobile, tractor electromechanical products, instrument, light industrial machinery, household hardware, electrical appliances and other products. This standard does not apply to the roller shears, flying shears, open coils, shearing and the cutting of the metal. ????? When this standard cant meet the requirements of shear panel and stamping the slab or allowed the use of more than the provisions of this standard tolerance, dimension tolerance should be separate or indicate the technical requirements of the element. The two terms The width of the cutting edge of the blade cutting edge to the opposite side. Figure 1 is shown in size b. Cut the length of the plate by cutting the blade of the plate. This is shown in figure 1. The shearing parts of the product are cut from the plate, and the parts of the metal are said to be cut. Three precision grade The level of accuracy of shearing width, shear straightness and shear perpendicularity is divided into A and B. The accuracy grade of the 3.2 shear height is divided into E, F, and G three. Shear width, linear degree, vertical tolerance The tolerance of shearing width is specified in table 1. Form?????? mm Form?????? mm The thickness of the material fine ?? Degree etc. Shear width????? level 2 or less 2 ~ 4 4 ~ 7 7 ~ 12 a. B a. B a. B a. B 120 or less + / - 0.4 + / - 0.8 + / - 0.5 + / - 1.0 + / - 0.8 + / - 1.5 + / - 1.2 + / - 2.0 120 ~ 315 + / - 0.6 + / - 0.7 + / - 1.0 + / - 1.5 315 ~ 500 + / - 0.8 + / - 1.2 + / - 1.0 + / - 1.5 + / - 1.2 + / - 2.0 + / - 1.8 +