剪切下料(国外英文资料).docVIP

剪切下料(国外英文资料) Shearing blanking In stamping, shear is one of the most basic processes. The cutting task is based on the requirement of stamping process to cut the material into the blanks that are suitable for stamping process, material or other shape. Choose shear equipment reasonably, properly layout and improve mechanization and automation degree, shear work to improve the shearing quality, improve production efficiency, improve labor condition, improve material utilization, reduce the production cost is of great significance. Shear mode Depending on the size of the batch, the size of the shear and the size of the shear, the cutting is usually adopted in the following ways: The hand shear is cut with the trim of the material or semi-finished product which is used for the unit production. Hand shears apply to the thickness of the plate within a millimeter. The bench shear is suitable for the plate of 1.0-2.0 mm thick. The shear shear of the vibration shear is clipped by the shear blade, and the shear blade is pressed against the fixed edge of the shear blade to make a rapid reciprocating motion, which can reach between 1200 and 2000 times per minute. Vibration shear can be used to shear the blank of a straight line or curve of a thickness of 2 mm. The blade of vibration shear is easy to wear, the shear section has the burr, the production efficiency is low, applicable to single piece or small batch production. The shear disc of the disc shears is made of disc, and the knife is rotated in the same speed and opposite direction when shearing. The cut is made by the friction between the material itself and the blade, which is used to complete the shear line or curve. The shear in the shearing of the door of the dragon door can be divided into two kinds: flat edge shears and inclined edge shears. The shear on the cutting edge of the blade. The top and bottom of the blade are parallel, and the plate is sheared throughout the width. The hair is flat and straight after th