北航14春《钢结构设计道理》在线功课二(国外英文资料).docVIP

北航14春《钢结构设计原理》在线作业二(国外英文资料) The principle of structural design of steel structure in beihang is two Test scores: 100 test time: - test scores: 100 One, single topic (10 questions, 40 points). Score: 40 At present, the design of steel structure in China () A. all use the approximate probabilistic limit state design method based on probability theory B. The limit state design method that is expressed by the component coefficients In addition to the calculation of allowable stress and stress in elastic state, the method of approximate probability limit state design based on probability theory is adopted D. Partially adopt the elastic method and the partial plastic method Answer: C 4 points: 4 The local stability of the zigzag component is related to the stress gradient on the edge of the abdominal plate, and the value of the alpha 0 is (). A. 0 1 B. C. 1.6 2 D. Answer: D 4 points: 4 For the hot rolled H bar beam with uniform load, it should be calculated (). The bending strength, the bending of the abdominal plate, the overall stability and local stability Resistance to bending strength, shear strength, overall stability and local stability C. the bending strength and the pressure strength of the edge of the peritoneal plate are stable D. Bending strength, shear strength, overall stability and deflection Answer: D 4 points: 4 When the overall stability of the composite beam is not supported by lateral and lateral support, it is advisable to adopt (). A. increase the area of the beam B. increase the height of the beam Increase the width of the flaps Increase the thickness of the abdominal plate Answer: C 4 points: 4 Welding residual stresses do not affect the components (). Integral stability Static strength C. stiffness Local stability Answer: B 4 points: 4 The design of the steel plate is the most intense. A. 16 mm B. 20 mm C. the 25 mm D. 30 mm Answer: A, 4 points: 4 The guarantee condition for the partial stability of the column is h0 / tw, which is not greater tha