pSeries的管理和日常故障处理.pptVIP

定时的mail报错信息 故障的处理 每天定时收到mail报错信息，而所指的硬件确实是好的。这种情况经常发生在系统意外掉电后，或更换设备后没有运行诊断程序。 处理方法 #diag 选高级诊断(Advanced Diagnostics Routines) 选系统检查(System Verfication) 选mail里所指的设备，如果报电源、风扇故障，选择sysplanar0 进行检查。 如果硬件确实没有问题，诊断程序会提示该设备曾经有出错信息，问是否已更换或更正？选中该设备按F7 确认。 退出诊断程序，如果还是继续收到mail，通知IBM ADVANCED DIAGNOSTIC SELECTION 801006 From the list below, select any number of resources by moving the cursor to the resource and pressing Enter. --用回车选中设备 To cancel the selection, press Enter again. To list the supported tasks for the resource highlighted, press List. Once all selections have been made, press Commit. To exit without selecting a resource, press the Exit key. [TOP] All Resources This selection will select all the resources currently displayed. + sysplanar0 00-00 System Planar --选中的设备前有+号 mem0 00-00 Memory proc0 00-00 Processor L2cache0 00-00 L2 Cache proc1 00-01 Processor scsi1 30-58 Wide SCSI I/O Controller [MORE...24] F1=Help F4=List F7=Commit Esc+0=Exit F3=Previous Menu ^ 选完设备后按F7继续 RESOURCE REPAIR ACTION 801015 The following list of resources have errors logged against them in the AIX error log. （以下设备曾经有出错记录） Select a resource if it has been replaced recently or has had corrective actions performed against it. This will update the AIX error log to prevent diagnostics from performing Error Log Analysis on the obsolete error log entries for the resource. （是否已修复？） To select a resource, move the cursor to the resource and press Enter. To cancel the selection, press Enter again. Once all selections have been made, press Commit. To exit without selecting a resource, press Exit. + sysplanar0 Available 00-00 System Planar ^用Enter键选中该设备，前面会出现+号 F1=Help F4=List