AS NZS 2589-2007 part 2.doc

AS/NZS 2589:2007 SECTION 2 MATERIALS 第二部分 材料 GENERAL 2.1总则 This Section sets out requirements for the materials used in common gypsum wall and ceiling lining systems. The materials shall be fit for the intended use. 就普通的石膏墙面和天花板系列材料而言，这个部分提出了一些要求。 GYPSUM PLASTERBOARD LINING 2.2石膏板 Gypsum plasterboard linings shall comply with AS/NZS 2588. 石膏板应该和AS/NZS标准一致。 2.3 FIBRE-REINFORCED GYPSUM LINING 2.3纤维加固石膏板 A sheet lining material composed of gypsum plaster and fibre reinforcement forming a stiff body, one surface of which is smooth and suitable for decoration. 一块板状材料由石膏板和纤维强化硬体组成，其中一个表面是光滑和适合装饰的。 NOTE: For manufacturing guidance, refer to the ‘Code of Practice’ issued by the Fibrous Plaster Council of Australia and New Zealand. 注意：就相关参考指南，请参考澳大利亚和新西兰纤维石膏委员会的执行惯例。 GYPSUM CORNICE 2.3石膏檐口 Paper-faced or fibre-reinforced non-load-bearing ornamental gypsum plaster shapes for architectural embellishment of wall and ceiling junctions. 纸张饰面或者无负荷纤维加强石膏成形的作用在墙面和天花板的收边条处。 FRAMING SUBSTRATES 2.4成行 Gypsum linings require a relatively stable substrate at the time of installation in order to minimize in-service surface defects. 在安装的时候，为了减少作用于表面的缺陷，石膏板需要一个相对而言比较稳定的底层。 Where adhesion of gypsum linings is required, surfaces shall be free of oil, grease, dust and other foreign materials detrimental to the adhesive bond. Where surface treatments are required, which may adversely affect bond performance, such performance shall be verified by testing in accordance with AS 2753. 在需要石膏板支持的地方，石膏板表层应该是无油渍、灰尘和其它会给胶粘带带来污染的其它外来物质。在与AS2753标准相符的情况下，一些需要处理的地方而反过来影响到性能的表面操作有待通过测试来得以证实。 2.6 TIMBER FRAMING 2.6木箱 2.6.1 General 2.6.1总则 Timber framing to which gypsum lining is fixed shall comply with the following: 一个木箱的石膏板的安装应该与以下细项保持一致： (a) For Australia—AS 1684.1, AS 1684.2, AS 1684.3, AS 1684.4, AS 1720.1, AS 1720.2 or the BCA. （a）对于澳大利亚，应符合AS 1684.1, AS 1684.2, AS 1684.3, AS 1684.4, AS 1720.1, AS 1720.2 或者 BCA规则。 (b) For New Zealand—NZS 3602, NZS