粉煤灰提铝残渣制备硅酸钙板的工艺优化研究.pdfVIP

学兔兔 新 建魄 中国科技核心期刊 粉燥灰提铝残渲制备硅酸钙板的 工艺优化研究 刘晓婷，王宝冬，肖永丰，孙琦 (北京低碳清洁能源研究所，北京 10221 1) 摘要：以神华国华准格尔电厂粉煤灰提铝残渣为原料制备硅酸钙板，采用压制成型方法及JMP软件响应曲面设计进行硅酸钙 板制备工艺优化，结果表明：增强纤维掺量对硅酸钙板的抗折强度影响最大，其次是成型压力，再次是保压时间，其中成型压力与保 压时间存在二次项的负相关，得到了预测抗折强度的数据拟合模型；通过实验验证发现，拟合模型精准度较高，预测偏差仅4．7％，以 此拟合模型可以预测得到不同规格硅酸钙板的制备工艺条件，制得抗折强度符合Jcfr 564．1—2008标准的硅酸钙板。 关键词：提铝残渣；硅酸钙板；JMP软件 中图分类号：TU52 文献标识码：A 文章编号：1001—702X(2015)01—0083—03 Study of preparation process optimization of calcium silicate board by using JMP LIU Xiaoting，WANG Boodong，XIA0 Yongfeng，SUN Qi (National Institute of Clean—and-Low Carbon Energy，Beijing 10221 1，China) Abstract：Optimize the preparation process of calcium silicate board from residue left behind extracting alumina from fly ash of Shenhua Guohua Zhunger Power Plant by using pressure molding method and JMP software．The results show that the order of factors influencing the calcium silicate board S bending strength is fiber content，molding pressure and pressure holding time，and there is a negative correlation between molding pressure and pressure holding time．The bending strength can be forecasted based on the fitted model，of which the prediction deviation is only 4．7％ through tests．The conditions for calcium silicate board prepa— ration with different bending pressure can be forecasted by the fitted mode1．Calcium silicate boards in accordance with JC／T 564．1—20o8 standards can be prepared． Key words：residue left behind extracting alumina，calcium silicate board，JMP software