钢筋混凝土受弯构件的延性及弯矩重分布.pdfVIP

学兔兔 第27卷 第2期 建筑科学与工程学报 Vo1．27 NO．2 2010年6月 Journal of Architecture and Civil Engineering June 2010 文章编号：1673—2049(2010)02—0038 07 钢筋混凝土受弯构件的延性及弯矩重分布 常莹莹，贡金鑫 (大连理工大学 建设工程学部，辽宁 大连 u6024) 摘要：研究了钢筋混凝土受弯构件延性系数和塑性铰转动能力的计算方法，给出了受拉钢筋屈服和 混凝土达到极限压应变或受拉钢筋达到极限拉应变时混凝土受压区高度的计算公式，在此基础上， 比较了中国规范、美国规范和欧洲规范规定的最小和最大纵向钢筋配筋率范围内构件的塑性铰转 动能力，分析了塑性弯矩重分布系数与相对受压区高度的关系。研究结果表明：由于中国规范规定 的最大纵向钢筋配筋率对应于界限破坏，构件配筋率达到最大配筋率时构件已经不具有塑性变形 能力，即使没有达到最大配筋率，变形能力也不大。 关键词：钢筋混凝土；受弯构件；延性；弯矩重分布；配筋率 中图分类号：TU375．1 文献标志码：A Ductility and Moment Redistribution of Reinforced Concrete Flexural Members CHANG Ying—ying，GONG Jin—xin (Faculty of Infrastructure Engineering，Dalian University of Technology，Dalian 116024，Liaoning，China) Abstract：The method for calculating the ductility coefficient and plastic hinge rotation capacity of the reinforced concrete flexural members was investigated，and the calculation formulas for determining the depth of compression zone when tension steel yielded and concrete strain reached ultimate compressive strain or steel strain reached ultimate tensile strain were given．On the basis of these，the plastic rotation capacities of members in the range of minimum and maximum reinforcement ratios of longitudinal steel specified in Chinese，American and European codes were compared．The relations between the coefficients of plastic moment redistribution and relative depths of compression zone were studied．Research results show that the member hasn’t any plastic deformation capacity in the case of maximum rein