给水排水工程水厂方向毕业设计答辩.docxVIP

邵阳市第四水厂给水工程扩大初步设计中文摘要本次设计针对邵阳市的一个片区进行供水设计规划，并建设一级泵站，二级泵站以及一个单独的自来水厂，设计针对该片区的建筑分布，首先进行管网部分的设计和规划，并且进行管网平差得到二级泵站设计时所需的扬程以及流量参数，进行二级泵站的设计，再根据水源的原水资料参考国家规范可以得到出水水质标准，两者对比后选取设计工艺流程，此次设计选择的流程为管式静态混合器到折板絮凝池到斜管沉淀池再到V型滤池，最后注入清水池，由二级泵站供给用户，在一泵站的设计方面采用自流管的方式引水，所以设计共分为管网设计部分，水厂设计部分，二级泵站设计部分，一级泵站设计部分，最后进行本次设计的大概预算。关键词：邵阳市；管网设计；水厂设计；二级泵站；一级泵站。abstractThis design for a district of shaoyang city water supply planning design, and construction level of pumping station, secondary pumping station, and a separate water plant, the design for the building distribution of the area, the first part of pipe network design and planning, and get the secondary pump station design of pipe network adjustment needed to lift and flow parameters, for the design of the secondary pump station, and then based on the raw water of water data can get out of the water quality standard of reference state, both comparisons after selecting design process, the design selection process for the tubular static mixer to the folded plate flocculation pool to inclined tube sedimentation tank to V filter, finally into the clear water reserviors, supplied by the secondary pump station of users, in the design of a pumping station with the method of gravity pipe water diversion, so the design will be divided into network design part, waterworks design part, secondary pumping station design, level of pumping station design part, finally the design about the budget.Key words: shaoyang city;Network design;Water plant design;The secondary pumping station;Level of pumping station.第一部分：毕业设计说明书1第1章设计原始数据21.1工程概况21.1.1城市概述21.1.2自然条件21.1.3水源状况21.1.4水处理用材料与药剂资料31.2 用水资料41.2.1居民生活用水变化曲线41.2.2公共建筑、生产企业等集中用水量表41.3城市规划图(见附图)5第2章管网设计部分62.1最高日设计用水量（近期）62.1.1城市最高日居民生活用水量62.1.2公共建筑、生产企业等集中用水量62.1.3浇洒道路和绿化用水量62.1.4管网漏失水量62.1.5未预见用水量62.1.6最高日设计用水量62.2最高日设计用水量（远期）62.2.1城市最高日居民生活用水量62.2.2公共建筑、生产企业等集中用水量62.2.3浇洒道路和绿化用水量72.2.4管网漏失水量72.2.5未预见用水量72.2.6最高日设计用水量72.3最高日各小时用水量曲线72.4消防用水量计算：82.5清水池容积和尺寸的计算82.6水塔容积和尺寸的计算82.7管网设计82.8管网平差9第3章水厂设计部分103.1总