1固废课程设计(国外英文资料).docVIP

1固废课程设计(3) volume: the determination of the volume of biogas is an important indicator of design. The biogas design is too small to make full use of raw materials and meet the requirements of use. Too big, not enough raw material, the biogas pool utilization is low, waste investment and material. Therefore, the volume of biogas should be determined according to the conditions of fermentation and the requirement of the user and the rate of gas production.Rural households use biogas (biogas), which is currently living at an average of 0.2 to 0.3 meters per person per day. For example, a family of five needs a daily gas amount of 1.5m. At present, the moisture content of the water pressure digester is 0.15m 3/3 of the liquid.(4) the biogas pool is generated by the fermentation of methane in the pool to produce pressure from the hydraulic pressure to the hydraulic pressure. The determination of the storage volume is calculated by half the amount of methane produced per day by the biogas.(5) the biogas load: the load is the force that is applied to the biogas pool, the weight that is borne by the unit area. The methane tank itself weighs 2.5 tons/meter 3; Ground and ground disposal load of 2.5t/mi3; The fermented raw materials in the pool 1.2 tons/meter 3; The pressure is 1 ton/meter 2 in the tank. The roof of the pool and the animal bearing capacity are 1.5t/m 2. In combination with the above factors, the reservoir load of the biogas pool is 5 tons/meter 2.Design of water pressure methane fermentation pondThe purpose of the course designThrough curriculum design further digestion and consolidate what they have learned in this course content, and makes the knowledge systematization, training by using the theory of learned knowledge to design the biogas preliminary ability. By design, understand the contents of the engineering design, the method and steps, cultivation of anaerobic system design scheme, design calculation and drawing of engineering drawing, the ability to