LED镀银光亮剂的应用(国外英文资料).doc

LED镀银光亮剂的应用 Shenzhen huali surface treatment technology co., LTD LED light silvered with the instruction manual A list, Hl-sp201 is a cyanide plating process for non-metallic brighteners, dedicated to the electronic industry of LED series electroplating, and its process characteristics are: Light brightness, can reach 2.0-2.4 High purity, non-metallic gloss. Electrical signals are good. The coating is soft and dispersing ability. Strong coverage. Two, sedimentary characteristics Purity (%) Hardness (25g) Sedimentation density (g/cc) Deposition density (mg/m.d) Efficiency (mg/A min) 1 mu m required time - 1A/dm2 - 10 A/dm2 - 100 - A/dm2 99.9 100-130 10.5 105 67 1.5 minutes 9.5 seconds 0.95 seconds 3, required equipment Tank pump heat-resistant glass, poly tetrafluoroethylene, polypropylene, PVC, hdpe or hard rubber chemicals. Heating, cooling equipment ceramic, stainless steel, titanium or teflon. The filter recommends continuous filtration of the polypropylene filter. Filter before use should be 20 g/l of potassium hydroxide solution soak for an hour (80-90 ℃). The commutator ripple coefficient is less than 3%, which is controlled by voltage, ammeter and precision current. Recommended use of the ammeter. For best effect, use titanium basket for silver anode. It can also be used in bagged high purity silver anode or platinum stainless steel anode. The anode cathode ratio is greater than 1:1. Stirring is required for gentle mechanical mixing and/or solution movement. Dont use air stirring. Ventilation recommendations. High temperature or high current operation should be strengthened. The effect of the composition function and operation parameters Silver in the coating exists in the form of silver cyanide. The higher the amount of silver, the higher the current density. The amount of silver is maintained by anodic dissolving or by adding AgCN (using inert anode). Potassium cyanide and silver form chromium compounds, which can help the electrolyte and the plating abilit