活性污泥造就方法(国外英文资料).docVIP

活性污泥培养方法 According to the specific conditions of the water, water quality and treatment field of wastewater treatment, the method of raising the active sludge can be developed by means of the method of the method of the method of raising and raising and the continuous cultivation method. The continuous culture method can be divided into three kinds: low load continuous culture, high load continuous culture and inoculation culture. What is the intermittent culture of activated sludge The interval training method is a full aeration tank filled with water, then stops the water and starts to be exposed (only to the air and not the water). After 2 ~ 3 days, it will stop aerating, it will sink for 1 ~ 1.5 hours, then it will enter some fresh water, about 1/5 of the volume of aeration pool. Cycle are stuffy after exposure, static sink, water three process, but each time into the water should be increased than last time, but every time boring exposure time should be less than last time, increase the number of the water. When the temperature of the sewage in 15 ~ 20 ℃, using this method after 15 days or so, it can make the sludge concentration in aeration tank more than 1 g/L, and mixture of sludge settling ratio (Sy) reached 15% ~ 20%. At this time, it is stopped to be exposed, the continuous water continues to aerage, and begin to return sludge. The original reflux ratio should be smaller than that, which can be controlled at around 25%, and as the sludge concentration increases, the reflux ratio increases to the design value. What is the continuous culture of activated sludge The continuous cultivation method is to make the sewage water directly through the aeration tank and the sink of the activated sludge system, continuous water and discharge. The two sinks do not discharge the residual sludge, and the whole flow of the liquid aeration pools until the sludge concentration of the mixture reaches the design value. There are three types of concrete practices: Low load co