ISO5208-2008工业用阀门金属阀门的压力试验.docx

Reference number ISO 5208:2008(E) . ISO 2008 INTERNATIONAL STANDARD ISO 5208 Third edition 2008-08-01 Industrial valves — Pressure testing of metallic valves Robinetterie industrielle — Essais sous pression des appareils de robinetterie métalliques ISO 5208:2008(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobes licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobes licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. COPYRIGHT PROTECTED DOCUMENT . ISO 2008 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISOs member body in the country of the requester. ISO copyright office Case postale 56 ??CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@ Web Published in Switzerland ii . ISO 2008 – All rights reserved ISO 5208:2008(E) . ISO 2008 – All rights reserved iii Contents Page Foreword iv Introduction v 1 Scope 1 2 Terms and definitions 1 3 Conditions relevant to pressure testing2 3.1 Purchaser examination options 2 3.2 Witnessing2 3.3 Closure pressure testing options 3 4 Requirements for pressure