施耐德综保P631与可为GPS对时设置说明V1.0.docx

1、P631与GPS对时需开放如下三个地方的设置，P631只支持Amplitude modulated signal（调幅信号），格式为B122，此次可为的GPS格式为B120，B120包含B122格式。此三处需如图设置此处建议如图设置2、测试是否与GPS对时成功，需将上述三项关闭，修改如图所示的日期和时间，下载到设备后，再开放第1项的三项，最后查看设备是否对上。修改后务必要下载到设备3、对时后的效果如图，P631没有秒和毫秒的时间显示。4、注意，P631对年份不对时，需手动设置P631的年份。5、IGIG-B码规则。The name of an IRIG code format consists of a single letter plus 3 subsequent digits. Each letter or digit reflects an attribute of the corresponding IRIG code. The following table contains standard code formats defined in IRIG standard 200-98:?IRIG?A??IRIG?B??IRIG?D??IRIG?E??IRIG?G??IRIG?H?A000B000D001E001G001H001A003B003D002E002G002H002A130B120D111E111G006H111A132B122D112E112G141H112A133B123D121E121G142H121??D122E122G146H122The code format names are composed as described below:First letter:Rate DesignationABDEGH1000 PPS100 PPS1 PPM10 PPS10000 PPS1 PPS1st Digit:Form Designation01DC Level Shift (DCLS), width coded, no carrierSine wave carrier, amplitude modulated2nd Digit:Carrier Resolution01234No carrier(DCLS)100 Hz / 10 millisecond resolution1 kHz / 1 millisecond resolution10 kHz / 100 microsecond resolution100 kHz / 10 microsecond resolution3rd Digit:Coded Expressions01236BCD, CF, SBSBCD, CFBCDBCD, SBSBCD, BCD_YearAbbreviations used in the table above:BCD - Binary Coded Decimal, coding of time (HH,MM,SS,DDD)SBS - Straight Binary Second of day (0....86400)CF - Control Functions depending on the user application