局部外包钢管装配整体式柱抗震性能试验研究.pdfVIP

局部外包钢管装配整体式柱抗震性能试验研究 1 1 2 1 李青宁 ，何迪 ，王鹏 ，姜维山 （1.西安建筑科技大学土木工程学院，西安 710055 2.中联西北工程设计研究院，西安 710082） 摘要：提出一种高强复合螺旋箍筋约束混凝土、外包钢板箍和横穿栓筋连接的新型装配整体式柱。 通过对不同钢板箍厚度和轴压比下的 3 个装配式长柱与 1 个现浇长柱进行拟静力对比试验，证明这种装配 整体式柱抗震性能良好，节点连接安全可靠，可以代替现浇整体柱。以钢板箍厚度与轴压比为研究变量， 利用 ANSYS 对柱的滞回性能进行对比分析研究，结果表明:数值模拟与试验吻合较好，提出的装配整体式柱 ANSYS 数值分析模型合理可行，可运用 ANSYS 程序对装配整体式柱结构进行有限元数值模拟和受力性能研 究分析。 关键词：装配整体式柱； 拟静力试验； 数值模拟；滞回曲线；抗震性能 Experimental Study on Seismic Behavior of the Steel Tubular Assembly Column 1 1 2 1 LI Qingning ， He Di ， Wang Peng ，JIANG Weishan （School of Civil Engineering, Xi’an University of Architecture ＆Technology ,Xi’an 710055,China ） Abstract: A new kind of precast concrete segmental columns has been put forward in this paper. It’s core concrete is constrainted by high-strength compound spiral stirrups and the exterior steel plate hoop penetrated by the bolt bar used for the connection area. Comparing the three assembled long columns under different width of the exterior steel plate hoop and axial pressure ratio and the one cast-in-place long column, It shows that the new kind of precast concrete segmental columns are better for the anti-seismic capacity and safe in the node connection area so that the cast-in-place long column can be replaced. Using ANSYS FEM software to take contrastive analysis for the column of hysteretic behavior based on the width of the exterior steel plate hoop and axial pressure ratio, It proves that numerical simulation meets well with the experiment,the ANSYS numerical analysis model of precast concrete segmental columns is feasible and correct. The ANSYS FEM can be used for the numerical simulation and t