小元件的焊接(国外英文资料).docVIP

小元件的焊接(国外英文资料) Removal and welding of small components Guidance of 1. The small components in cell phone circuit include resistance, capacitance, inductance, transistor, etc. Due to phone small volume, powerful function, circuit is more complex, determines the element must be mounted with patch type (SMD), chip components compared with the traditional hole components, SMT components installed density is high, reduce the influence of the distribution of lead, enhances the ability to electromagnetic interference and radio frequency interference. For these small components, generally using a heat gun to remove and welding (welding can also use the soldering iron), when removing and the welding must grasp the wind, wind speed and wind direction, improper operation, not only the small components blow away, but also affected fish pond, will be around the small element also blows position or blow away. 2. Operation (1) the removal of small components Before use heat gun remove small components, be sure to mobile phone backup battery on the circuit board will be removed (especially the spare batteries are near the disassembling components close), otherwise, the backup battery is easy to heat explosion, pose a threat to the personal. Fix the circuit board on the mobile maintenance platform, turn on the light magnifying glass, and observe the location of the small components that are disassembled. Use a small brush to clean up the impurities around the small components and add a little bit of rosin water to the small components. Install the thin nozzle nozzle of the hot air gun, turn on the heat gun power switch, adjust the thermoelectric gun temperature switch between 2 and 3, the wind speed switch between 1 and 2. Hand with his fingers clamped up little components, another hand steady heat gun handle, keep the nozzle to remove small components perpendicular to a distance of 2 to 3 cm, along small components, uniform heating, nozzle shall not touch the small components. Remo