电解液抛光(国外英文资料).docVIP

电解液抛光(国外英文资料) Electrolyte index: (1) electrolyte density: 1.68-1.72 (2) electrolyte state: microyellow transparent liquid (3) the PH: 7 (4) electrolyte working voltage: 5-9v (5) the current density in the electrolyte (unit per square meter), 200 series 15-25 amperes, 300 series 10-15 amperes, 400 series 20-30 amperes. (6) electrolysis time: 5-10 minutes. (7) electrolysis per kilogram of processing area: 2 to 4 square, because the material difference processing surface area is different. (8) the electrolyte temperature: 50-75 ℃. Do not exceed 90 ℃ (9) the recommended process for electrolyzing and polishing: In addition to the oil removal and rust, the electrochemical polishing goes to wash and wash to wash and to wash and to protect. Electrochemical polishing, water and water Electrolyte maintenance: (1) before electrolysis, it must be disused to prevent oil pollution from being contaminated with polish or to cause a large amount of foam in the polishing liquid. Often measuring the electrolyte density, (2) if the density is small, that water, steam heating to remove excess water, if the density is big, that the moisture is less, can supplement moisture, but need to content determination of other substances, according to the actual situation to add. (3) the polishing liquid aging: electrolyte in long-term work, the workpiece on the surface of the nickel chrome iron ions dissolved into the polishing liquid solution of iron nickel chromium ion content increased, loss of polishing solution ability, raise the temperature, increase current have no effect, and the best way is to replace the new liquid, can all change, also can be replaced by 80% (4) regularly clean the cathode and bottom. Stereotype in the process of polishing surface adsorption had thick nickel iron impurities, influence the cathode conductive surface, the current decline, cathodic current density, so to clear out deposits on the cathode board in time. Impurities such as iron nickel chromium affect the li