脱硫吸收塔除雾器塌陷、喷嘴冲刷大梁分析处理(国外英文资料).docVIP

脱硫吸收塔除雾器塌陷、喷嘴冲刷大梁分析处理(国外英文资料) 2009.10 China Kunming 2009 2009 Collaboration Network Annual Meeting of Clean and energy China Efficient Coal - fired Power Generation Technology The desulfurization absorption tower has the collapse of the mist and the nozzle erosion girder analysis Guo-hua liu Datang anyang electric power generation liability co., LTD., the address: the huachang road in anyang, henan 1 zip code: 455004 abstract: anyang power plant # 9, 10 units desulfurization absorption tower found demister scaling after serious collapse, and causing damage to other equipment absorption tower, cause the net dont smoke Emissions can meet the design requirements of humidity, increase the absorption tower to fill water, make net flue pressure condenser water drainage, discharge plasma, block, the condenser and the The effect of corrosion, leakage and desulfurization of the horizontal flue in the horizontal flue, partial bypass and chimney is also affected. The suspension also found near the girder Part of the nozzle spray surface is used to flush the girder, and the girder is worn and corroded, which directly affects the safe operation of the desulfurization system. In this paper, the fouling and spray of the fog removal This paper analyzes the beam and puts forward Suggestions and solutions to improve the economy and safety of desulfurization system. Keywords: defectors collapse; Jam; Rinse; Strapping; The nozzle; Girder; Adjustment; Deal with 1. The introduction of the tslurry nozzle is one of the critical equipment in the desulfurization unit The atomization performance has an important influence on desulfurization efficiency and the absorber is wet The important equipment of desulfurization system is installed in the upper part of the absorber tower and fixed After corrosion treatment, the nozzle has a 120 degree spray The Angle, the nozzle spray Angle is not adjusted properly, it will cause the injection Angle to cover the girder and cause Erosion of girder beams,