程控器任务道理(国外英文资料).docVIP

程控器工作原理(国外英文资料) B - the state of the burner 2, B, C burner operation (heat) burner is running, according to the requirements of heat load controller running of air to the rated load or low flame position. The rated load is achieved through the auxiliary switch of the wind gate motor. C - use R to shut off control as the program stops, the fuel valve closes immediately, and the program starts and compiles the program. 4, blowing time after t6 - (used in the terminal fan blowing after G2 on 7), after blowing time shortly after the start, the recovery voltage on terminal 10, therefore throttle damper to the minimum position, throttle damper fully closed just triggered by terminal control signal on 11 after blowing finished recently. At the end of the burner, the terminal 8 holds the voltage. 5, t13 - the flame detection circuit may still receive a flame signal during this time, without triggering the burner block. Four, D - (- start position) the end of A control procedure when complete t6, program switch has control contactor reset to their original position, and disconnect switch, detector and flame simulation experiment to start again. However, when the burner is off, only the time delay due to the circuit NTC - resistance causes the fire signal to last for a few seconds and the lock can occur. Because the cosmic radiation causes a short ignition pulse, the burner cannot be turned off. Five, notice the matter 1, switches, fuse, ground and other devices must be in line with local safety procedures. Supply control units must be disconnected if they have to adjust the wiring and change the wiring. No more than 10 seconds when the reposition button of the SPC. Engineering principles The phase line and the middle line cannot be reversed. Maximum permissible input current: 5 continuous and peak 20 largest Ann (motor starting current) security restrictions heat switch (manual reset, the STB) generally have connection in the circuit. Remote reset: when the button EK2 recei