模具英语口语.doc

产品检讨 1. 和滑块干涉的倒勾请加料填平至滑块可以顺利滑动 (The undercut area where interfere with slide block need to be filled material to help the slider can move smoothly.) 2. 加肉太多 (The thickness is added too thick.) 3. 加肉面积太大 (The thickening area is too wide.) 4. GATE位置移位 (Gate position is moved.) 5. 滑块拆的位置 (The split line of slide block or the area of slide.) 6. 此处有尖角，填充困难 (This area is hard to be filled due to the sharp feature.) 7. 此处钢材太薄，强度不足而且不容易冷却 (The strength of this area is too weak and isn’t easy to get cold due to the steel too thin.) 8. 圆柱特征要有一半圆不可以拆在滑块上，以免粘滑块造成拉白，拉断 (The semicircle of cylinder avoids designing on slide block lest it will be pulled apart or cause drag mark) 9. 此处做斜销在作动时会削到成品肉厚 (The part will get damage if we make lifter in this area.) 10. 这个面是装配面，不能加料 (This is critical surface where is not allow to add material.) 11. 此处料位太厚，会有缩水，建议减料改善 (Owing to the shrinkage of the thickness that we suggest to reduce some wall thickness to improve it.) 12. 此面是不是外观面，此处做滑块的话会有夹线，是否可以接受 (Please confirm whether it is critical surface or not. Please confirm whether it is acceptable to has Slide split line if we have slide in this area. ) 13. 此处有倒勾，能否减料，使公母模靠破，不做滑块和斜销 (Please confirm whether we can reduce material to the area where have undercut as indicated to have shut off on cavity side. No slide block and lifter to be made. ) 14. 请尽快确认这种拆模方式和结构，否则会影响模期 (Please confirm the issues of Parting line, Gate position...Etc otherwise the lead-time will be extended.) 15. 此面是否有特殊要求，能否有顶针印 (Please confirm whether it is a critical surface or not and can we have E.J. pin mark on it.) 16. P.L面开在此处，模具上会有尖角和刀口，对模具寿命有影响 (There are sharp edges if set the parting line at here, It will reduce the tool life) 17. 加大拔模角，以便脱模顺利 (We would suggest to enlarging draft to help tool released.) 18. GATE做在此处的话