毕业设计规划论文(终稿).docVIP

本科毕业设计(论文) 题目：ARM的电动车电池监测模块 院（系） 电子信息工程学院 专 业 电子信息工程 班 级 090404 姓 名 靖宗轩 学 号 090404104 导 师 张 峰 2013年6月 基于ARM的电动车电池监测模块 摘 要 课题针对广泛应用而提出，以ARM处理器为核心，结合、串口通信技术设计一个可。 论文首先介绍模块的设计方案；然后针对课题所需要的相关技术及芯片进行了详细的介绍和分析，包括32位ARM处理器LPC2103、NOKIA5110液晶显示屏、MAX232及ADS1.2开发环境等；在此基础上进行了显示及接口模块的软硬件设计。在硬件设计方面，ARM处理器LPC2103接收和键上输入的指令，按照指令控制，同时利用NOKIA5110 LCD液晶显示屏把信息显示出来。软件设计基于集成开发环境ADS1.2，用C语言编写，包括串口通信程序、NOKIA5110 显示程序及键处理程序。 关键词：ARM；LPC2103；NOKIA5110；ADS1.2；MAX23Battery Monitoring Module for Electric Vehicles Based on ARM Abstract The battery monitoring must be part of the design of electronic products and electrical equipment, also is an integral part in the electrical field. This subject is put forword because of a wide range of applications of the battery monitoring,.The ARM processor is used as the core, combined with the voltage conversion, level conversion chip, serial communications technology to design a battery monitoring applying to a variety of amplitude battery .This completed the design of the electric vehicle battery monitoring module.Firstly， this paper introduces the design of the monitoring module firstly; then give a detailed description and analysis of related technologies and chips required for the issue, including a 32-bit ARM processor LPC2103, the NOKIA5110 LCD, MAX232 and ADS1.2 development environment; On the basis , the display, buzzer and interface module hardware and software are designed. In hardware design, the ARM processor LPC2103 receiver serial transmission voltage value and the command input from the keys to control the choice of the battery voltage amplitude, in accordance with the instructions, while uses NOKIA5110 LCD to diaplay voltage amplitude information. Software design based on the integrated development environment ADS1.2, written in C language, including serial communication program, A/D conversion process, NOKIA5110 display procedu