化工设备罐体和夹套的设计(国外英文资料).docVIP

化工设备罐体和夹套的设计(国外英文资料) The design of tank and clamp The jacketed reaction kettle is composed of two parts, the tank and the jacket. The tank body provides a certain amount of room for the material to complete its mixing process under the operating temperature and operating pressure. The heat transfer is the most common form of external heat transfer. It is a container that can form a sealed space outside the tank. It is simple and convenient. The design of the tank joint is mainly composed of the design of its structure, the determination of the dimensions of the parts and the calculation and the core of the strength. Structure design of tank and clamp The tank is usually a vertical cylindrical container with a roof, barrel, and bottom, which is installed on the base or platform. Roof pressure in a state of operation to choose the oval head, (with low atmospheric pressure or operating pressure and diameter of large equipment, roof can be used flat cover sheet metal manufacturing, set up on the thin plate made of steel beam, to support the agitator and its transmission device. The top and bottom respectively connected to the cylinder. Be used between the tank bottom and the cylinder body welding connection. The connection form of head and cylinder is a detachable connection. The type of jacket is the same as the tank. The size of the tank geometry is calculated Determine the diameter of the tube The process condition is given the volume of V, the diameter of the cylinder is estimated D1: D1 = = 1.058 m = 1058mm V -- the process condition given volume, m3; I -- the length ratio, I = The D1 estimate is rounded to the nominal diameter of 1000mm Determine the head size The inner diameter of an oval head is the same as the diameter of the tube Curved edge height h1 = 250 mm Straight edge height h2 = 25mm A = 1.625 m2 The head volume V = 0.1505 m3 The thickness of the head The quality of Determine the cylinder height Type in the The cylinder has a height of 1500 The reaction