后张法简支箱梁预应力施工工艺(国外英文资料).docVIP

后张法简支箱梁预应力施工工艺(国外英文资料) After the construction of the box girder of the box girder China railway 19 group, no.5 engineering co., LTD Keywords: three control, strength, elasto, age, control stress, tension, periodic calibration, periodic calibration, before use Content abstract: Zhang Fajian box girders after prestressed construction, the tensioning equipment including pumps, jacks, magnitude 0.25 shock oil pressure gauge, 1 x 7-15.2-1860 mpa raw materials adopt low relaxation strand. According to the process construction of the prestressed construction process, the drawing of the rod, the cleaning, the steel wire, the wire transfer, etc. The prestressing stress is performed in the three stages of pre-tensioning, the initial tension and the final tension, and the pre-tensioned three control: when the concrete reaches 35.5 MPa, the pre-tensioning can be carried out. Strength to meet the design requirements of 43.5 MPa, can be carried out at the beginning of tension, according to the site condition, forecast, early tension can be simultaneously, and advance, initial tension belt tension, tensioning the rear end of the movable beam; When the intensity of the concrete reached 53.5 MPa, and the modulus reached 35.5 GPa, the age was greater than 10 days. In the process of tension, the prestressed value is mainly the oil gauge reading, the extension value is auxiliary, and the three concentric, two synchronization. Prestressed equipment to do: periodic verification (jack use more than 1 months or 200 times), regular calibration (hydraulic table by collision or oil leakage, oil pointer cannot be returned to the zero point) and before using the check (tensioning, determine if the hydraulic table and jack is properly matched; make jack empty 2-3 times, determine the jacks and hydraulic pipe works) to ensure the construction process, the equipment can work normally. At the time of zhang, a warning sign and a police cordon were set on both sides of the beam. After tension, you sh