双主轴双工位四转台飞轮外圆弧段铣床的研究.pdfVIP

Vol. 46 No.5 四川大学学报(工程科学版) 第46 卷第5 期 2014 年9 月 JOURNAL OF SICHUAN UNIVERSITY (ENGINEERING SCIENCE EDmON) Sept. 2014 文章编号:1侃9-3087(2014 )05-0175，，(后 双主轴双工位四转台飞轮外圆弧段镜床的研究 王秋晓1 ，温科2 ，何彬2 (1.重庆大学机械传动国家重点实验室，重庆4(朋44;2. 重庆大学机械工程学院，重庆4(削44) 摘 要:提出了一种双主轴双工位四转台结构的新镜床，采用滑台的纵向进给和工件转台的周向进给形成极坐标 下的切削轨迹，利用工位转台的回转运动构成加工与装卸2 个工位，每个主位可同时锐削2 个飞轮的外圆弧段;针 对双主轴的对称式布局和两相互于涉的切削力对主轴箱同时作用，易引起振动，在 ANSYS 平台上分析了双主轴系 统的模态和谐响应动力学特性，优化了双主轴结构参数:阐述了一种新的极坐标直线插补算法，实现了外圆弧段的 连续加工。工艺实验表明:加工精度为0.02 mm，表面粗糙度为 RaO.8 ， 加工效率为3∞-4∞件/h。 关键词:双主轴;动态特性;极坐标;圆弧段 中圄分类号:TH122 文献标志码:A Research 00 a Milling Machine for Extemal Circular Arc S唔;meot of Flywheels Based 00 Double-spiodle Double-statioo Fo町-turntable 阳NG Qi山归。1 , WEN Ke2 ,HE Bin2 (1. State Key Lab. of Mechanical Transmission ,Chongqing Univ. ,Chongqing 4αx44 ,China; 2. Sch∞1 of Mechanical Eng. ,Chongqing Univ. , Chongqing 4仪则44 ， China) Abs衍act: To mill extemal circular 缸c segment efficiently ,a special milling machine for flywheels was designed based on double-spindle double-station four-tumtable ,which used the longitudinal feed of sliding table and circular feed of workpiece tumtable to form cu忧ing 让ajectoηin polar coordinates ,and u回d 由e rotary motion of station tumtable to constitute double stations of processing and handling , each of which could mill two workpieces 刨出e same time. Aiming at the symmetric layout of double-spindle and vibration produced 创s­ ily by double cutters ,the modal and harmonic responses of the spindle system were analyzed on ANSYS in order to optim