结构计算TSSD(国外英文资料).docVIP

结构计算TSSD(国外英文资料) The bending member longitudinal is calculated by pulling bar The project name... (1 Unit number: l-1 Second, design basis Design specification of concrete structure gb50010-2002 Third, calculating information Geometric parameter Section type: rectangle Section width: b = 400mm Section height: h = 800mm Material information Concrete grade: C20 fc = 9.6 N/mm2 ft = 1.10 N/mm2 Type: HRB335 fy = 300N/mm2 Minimum reinforcement rate: rho min = 0.200% The longitudinal reinforcement points to the near side: as = 35mm Force information M = 500.000 kN * M Design parameters Coefficient of structural importance: gamma = 1.0 Four, the computation process Calculate the effective height of cross section Ho = h - as 35 = = 800-765 mm Calculate the relative pressure zone height Xi b = beta 1 / (1 + fy/(Es * epsilon cu) = 0.80 / (1 + 300 / (2.0 * 105 * 0.0033) = 0.550 Determine the calculated coefficients Alpha s = gamma * M/(alpha 1 * fc * ho * ho) = 1.0 * 500.000 * 106 / (1.0 * 9.6 * 400 * 765 * 765) = 0.222 Calculate relative pressure area height Xi = 1 - SQRT (1-2 alpha s) = 1 - SQRT (1-2 * 0.222) = 0.255 is less than or equal to 0.550. Calculate the area of longitudinal tension As = alpha 1 * fc * ho * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * Check the minimum reinforcement ratio Rho = As/(b * h) = 2497 / (400 * 800) = 0.780% Rho = 0.780% is greater than rho min = 0.200%, satisfying the minimum reinforcement ratio requirement. The bending component is calculated The project name... (1 Unit number: l-1 Second, design basis Design specification of concrete structure gb50010-2002 Third, calculating information Geometric parameter Section type: rectangle Section width: b = 400mm Section height: h = 800mm Material information Concrete grade: C30 fc = 14.3 N/mm2 ft = 1.43 N/mm2 Type: HRB335 fyv = 300N/mm2 Spacing: s = 100mm Minimum band ratio: rho min = 0.200% The l