T0961-1995手工展砂法测定路面结构深度试验(国外英文资料).docVIP

T0961-1995手工铺砂法测定路面构造深度试验(国外英文资料) T0961-1995 manual sanding of pavement construction depth test method Purpose and scope of application This method is used to determine the surface structure of asphalt pavement and cement concrete surface. Main detection equipment Artificial sanding machine: consists of cylinder and push plate. 2.1.1 quantity of sand barrel: shape size as shown in figure T 0961-1, one end is closed, the volume of 25 mL + / - 0.15 mL, by weighing the quality of the water in the sand barrel to determine its volume V, and adjust the height, make its volume within the rules. With a special scrape rule, you can scrape the top of the cylinder. 2.1.2 push plate: the shape dimension is shown in figure T 0961-2. The push plate should be made of wood or aluminum, with a diameter of 50mm and a rubber sheet with a thickness of 1.5 mm thick, with a cylinder handle on top. Scrape ruler: use 30cm steel plate instead. Figure T 0961-1 (mm) figure T 0961-2 push plate (unit: mm) 2.2 amount of sand: sufficient amount of dry, clean, uniform sand, 0.15 mm ~ 0.3 mm. 2.3 measures: steel tape measures, steel tape measures, or the use of a special construction depth scale with the diameter of the diameter as a unit of scale. Other: pack sand container (small shovel), broom or brush, windshield etc. 3 test preparation Quantity of sand preparation: clean the fine sand, dry the sieve, take 0.15 mm ~ 0.3 mm in the proper container. The amount of sand can only be used once on the road, and should not be reused. To determine the location of the cross section of the location of the measurement point, the method of random sampling for the test section is determined. The points should be carried on the track of the driveway, not less than 1m from the edge of the road. 4 test steps 4.1 use a broom or brush to clean the surface area near the point of measurement, not less than 30cm by 30cm. 4.2 with a spatula pack sand, sand along the wall vector tube filled with sand, in the mobile s