接地装置(国外英文资料).docVIP

接地安装(国外英文资料) Installation of ground installations Grounding devices are an indispensable part of overhead lines. When lightning strikes, the pole tower and the lightning conductor generate several hundred thousand The high voltage of the piezoelectric and the thousands of ampere current can wreak havoc on the circuit equipment. Grounding devices will be powerful The lightning flow enters the earth, reduces voltage and ACTS as a protective device. Most of the ground equipment is buried under ground The construction should be installed strictly according to the regulation, the value of the ground resistance is measured and qualified to be put into operation. (1) the installation and requirements of the grounding line The ground of the concrete pole of an overhead line is not permitted to use the concrete pole of prestressed reinforced concrete The ground leads to the lower line, and the other is to use the main reinforcement of the bar to make the grounding wire, which should make the lightning conductor and the bar inside the bar Reliable connection. The connection method can be used to connect the straps of the lightning rod to the pole through the heart bolt or to be used separately Line. The other end of the line is connected to the lightning rod with the iron and the trench wire and the ground nut connected to the lower part of the pole Good. The tower itself can be seen as a ground body without any additional lead. If there is no grounding nut on the prestressed reinforced concrete pole or bar, the line should be drawn down again by the pole and the section must not be less than. The lead of the ground body, if the galvanized steel wire is used, the section of the transmission line is the section of the distribution line. When the ground leads down the pole, it should be made as short as possible and fixed with iron wire. When the ground is drawn under the wire, the connection shall not be possible except for the grounding nut connection. Ground bolt due Spring