教你维修潜水泵(国外英文资料).docVIP

教你维修潜水泵(国外英文资料) The submersible pump is made up of asynchronous motors and pumps, widely used in agricultural drainage and industrial water supply. There are several kinds of dry, oil-immersed and water-cooled. Because of pump body into the water for a long time work, and in some parts of the water quality is bad, the poor quality of power grid, the maintenance experience is insufficient, so high failure rate, maintenance amount is larger. A common fault of the submersible pump 1, the leakage Leakage is the most common fault of the submersible pump, and is also one of the most dangerous factors for personal safety. Closed knife for fault phenomenon, leakage protector in the transformer substations will trip (if no leakage protector is pretty dangerous, will cause the motor burn out). This is mainly due to the water in the submersible pump pump, causing the insulation resistance of the submersible pump motor winding to decrease, causing the protective action. At this time with a shaking table or multimeter R x 10 k Ω block, measuring machine winding leakage resistance of shell has certain. The long term use of the water pump causes severe wear and tear on the mechanical seal face, and the water seeps through and the wet motor winding forms leakage. The submersible submersible pump motors can be placed in the oven, or dried with 100-200w incandescent bulbs. The insulation resistance is infinite, then the mechanical seal is replaced and then the pump is installed and ready for use. 2, the oil The main result of the submerged pump is due to the serious wear and tear of the sealing box, resulting in the leakage of the oil chamber of the sealing box and the sealing of the outlet box. The oil spill in the sealed box oil chamber is visible in the water section. There is a refueling hole at the water inlet, screw down the screw and see if the oil room is flooded. If the oil chamber is flooded, the seal box should be replaced to prevent the oil chamber from entering into the