教诲心思学(国外英文资料).docVIP

教育心理学(国外英文资料) The allowable pressure drop of the two-pass regulator is not less than 40kPa. According to the above, can be a rough estimate of about 100 m high a high-rise building air conditioning water system pressure loss, which is needed for the circulating water pump head: 1. The water chiller resistance: take 80 kPa (8 m water column). Pipe resistance: it is 50 kPa to remove the dirt, water collector, water separator and pipe in the freezer room. The friction resistance of 300 by 300 and 200 Pa/m for the distribution of the side pipe is 300 * 200 = 60, 000 Pa = 60 kPa. If the local resistance of the distribution side is 50% of the friction resistance, the resistance is 60 kPa. The total resistance of the system line is 50 kPa + 60 kPa + 30 kPa = 140 kPa (14m water column); 5. As a result, the water system of resistance to the sum of the parts: kPa + 140 kPa + 45 kPa + 40 kPa = 305 kPa 80 according to the result of the above estimates, can master basic similar size of the structure of the air conditioning water system pressure loss value range, especially should prevent because of without calculation, too conservative, and the system pressure loss estimation is too large, water pump lift to energy curve such as Cheng Xuan too large, lead to waste. Normal work: n 6 automatic control principle course design 1.3 speed range water pump speed regulation is generally refers to reduce the rated revolution of the pump. When the pump speed is used, the original water pump and motor is designed according to the state power frequency of the operation parameters are changed larger, such as pipeline characteristic curve, and other factors such as the pump parallel operation, variable speed pump will be a certain influence on the range of speed regulation. It will be difficult to realize the purpose of saving energy, so it is impossible to adjust the speed limit. It is generally believed that the frequency conversion speed should not be less than 50% of the rated speed, pre