柱板混凝土浇筑平安及交底(国外英文资料).docVIP

柱板混凝土浇筑安全及交底(国外英文资料) Check the concrete with a high standard, and then scrape it flat with a ruler. Use the spatula in the construction seam or in the embedded parts and the inserts. Concrete is not allowed to be spread by vibratory rod. (5) position of the construction; The construction seam should be placed in the middle 1/3 range of the secondary beam span. The surface of the construction shall be perpendicular to the axis of the beam or the page and not to be left. The construction seam should be secured by boards or steel wire mesh. (6) when the compressive strength of the concrete is not less than 1.2 mpa, it is allowed to continue pouring. Before continue pouring concrete, construction joints of concrete surface should be cut hair, remove the floating stones, and after the water is clean, to a layer of cement slurry, and then continue pouring concrete, should meticulous manipulation vibrated, the old and new concrete. Shear wall concrete: (1) casting wall concrete should be continuous, interval time should not be more than 2 h, each casting thickness control in 60 cm, must therefore be arranged in advance under the concrete material point location and number of vibrator operator. (2) the vibrating rod mobile spacing should be less than 40 cm, each point of the duration of vibration in surface laitance degrees, to enable the lower level of concrete combined into a whole, 5 cm should be inserted into the lower concrete vibrator. It is necessary to vibrate on both sides of the hole to prevent leakage, and the ash height should be broadly consistent. The bottom template of the big hole should be opened and vibrates here. (3) after the concrete wall is finished, the steel bar that will be dumped from the top will be cleaned up, and the concrete will be flattened on the high line by the wooden float 8, stair concrete pouring: (1) flight from top to bottom pouring concrete, first vibrated concrete floor, reach a step position again with step concrete casting, conti