模具设计选择题(国外英文资料).doc

模具设计选择题(国外英文资料) 3, select the question (fill in the blanks with the correct answer number) The stage of the plastic deformation in the process of cutting deformation forms ___A________. A, the light belt B, the burr C, the fault zone When falling, the principle of the blade size calculation is to determine ____a________. A, groove size B, punch size C, convex, concave dimensions tolerance 3. When the blanking clearance is bigger, due to the material elastic recovery after blanking, make the punching size ____A____ convex mold size, shipping/size _____A___ concave die size. A, greater than B, greater than C, less than, less than D, less than, greater than In order to reduce the cutting force, the method of ______A_____ should be adopted to reduce the cutting force. A, the staircase punch blanking B, the inclined blade blanking C, heating blanking 5,. In order to make the blanking process smoothly, the infarction in the die of salt pieces or waste from the concave die hole in the cutting direction, the force required to called ______A_____. A, the thrust force B, the discharge force C, the top force To make one piece of work, push the force to be F, use the rigid discharge, the following way, the total pressure is _____B______. A, cutting force + unloading force B, thrust force C, cutting force + unloader force 7, if the mould pressure center through the center of the slider are stamping slider will subject to eccentric load, lead to guide and mold parts ______B_____. A, normal wear B, abnormal wear C, initial wear The shape and inner shape of the blanking pieces have higher position accuracy requirements. A, guide plate type B, progressive die C, composite mold 9, the mold for the high-speed pressure machine is ______B_____. A, guide plate type B, progressive die C, composite mold In the cutting mode of the guide column, the lead and the guide are used in conjunction with _____C_____. A, H7 / m6 B, H7 / r6, C, H7 / h6 In the case of a pushboard or top plate and a co