溷凝土论文施工技巧论文：大体积溷凝土施工技巧办法(国外英文资料).docVIP

溷凝土论文施工技术论文：大体积溷凝土施工技术措施(国外英文资料) Academic publishing and writing resource platform: QQ: 275252867 Technical papers on concrete paper construction: the technical measures of large-volume concrete construction 1. Introduction Large concrete bottom plate, high strength grade concrete wall, column and the basement of girder and board. The construction technique of large concrete is very high, especially in the construction, to prevent the temperature difference caused by the concrete hydrating heat to produce the temperature stress crack. Therefore, it is necessary to make full preparation work from material selection, technical measures, etc., so as to ensure the smooth construction of the large concrete. Construction method 2.1 template design When the design of the template is designed, it is necessary to ensure the strength, stiffness and stability of the form. The maximum lateral pressure of the template is related to the main influencing factors such as the velocity of the concrete, the height, density, slump, temperature and admixture. The pouring of the large concrete (1) after the concrete pump is started, the pump will be pumped in the right amount of water to meet the contact part of the concrete pump, the piston and the inner wall of the conveyor tube. Confirmed by the pumping water, no foreign body in concrete pump and pipeline, the slurry, or 1:2 cement mortar, or with other ingredients the same except the coarse aggregate in concrete mixing ratio of cement mortar concrete pump lubrication and duct wall. The lubricated slurry or cement mortar should be dispersed and not be concentrated in one place. The concrete pump will be carried out continuously, and the hopper shall have enough concrete. If it must be interrupted, the time limit shall not exceed the duration permitted by the concrete from stirring to the pouring. (2) large volume concrete pouring with 3-7 ㎝ stones, according to the concrete amount 20% - 20% added, casting by hierarchical segmentatio